Radio-Controlled-Hobbies.com

h1 { font-family: Arial, Helvetica, sans-serif; font-size: 16px; font-weight: bold; color: #000000; margin:1px; line-height: 14px} --> The New 2.4Ghz Yak 54 - Brushless + LiPo - Ready to Fly! The hottest aerobatic & 3D airplane! Full Review on RCGroups.com The Yak-54 is an all foam plane with geared motor, 11 x 4.7 prop and more servo throw movement than you?ll ever need - even for a 3D machine. My plane was red, blue and yellow, completely decaled, painted and ready to go. At less than 600 grams, I had a really good 3D machine for some extreme flying. 1.Specification: Length: 890mm/35in Wing Span: 930mm/36.6in Flying Weight: 580g/19oz Propeller: AT1147 Battery: 3 cell 11.1V (Li-Po) 1300mAh 2.Features: ★.Brushless Motor! ★.Brushless Speed Controller! ★.The Plane comes with a much better receiver! ★.This model is most suitable for Intermediate & Advanced flyers. Excellent slow-speed capability and stability. More flexibility in controlling with larger rudder. perfect aerobatics performance with powerful motor. Kit includes: Fully painted and decaled wing, tail and fuselage Landing gear Brushless in-runner with 5.2:1 gear box Three 11 x4.7 props Rubber spinner FMS Simulator on CD 11.1 volt 1300 mAh LiPo with Deans connectors installed LiPo 12V balancing charger with .3 to 1.0 amp adjustable input rate Screw driver and wrench Clear canopy with interior instrumentation and pilot seat backs All linkages, clevises and screws 4-channel transmitter with USB simulator cord 6-channel PPM receiver Kit Required Eight AA batteries Kit ContentsOther than a few screws to install for the tail, most everything is completed. My kit arrived almost unscathed, but the control horns were connected to the linkage clevises, and as the box was pressed, the linkages had nowhere to go but against the ailerons. Both of my ailerons on the interior portions had their hinge tape torn. Here's how it comes out of the box! Assembly Because you are able to fly the same day you receive the plane, the first thing to do is charge the battery. The LiPo charger is a balancing charger with an adjustable rate. While you may charge a 1300 mAh battery at 1.3 amps the charger provided only goes to one amp, so figure about 45 minutes to an hour to charge. Wing The wing is complete. I had to take some tape and reinforce the hinge line near the fuselage. The single servo is installed and uses a longer servo arm for maximum movement. I have seen many transmitter and servo setups that did not have the movement this system employs. It has the ability to move to 45 degrees of 3D aileron, elevator and rudder movement. The wing uses a forward locking, two pin attachment and a single wing bolt from the top side. Fuselage The fuselage is molded foam, and the molding vents show. The body is nicely painted with a gloss finish. The rudder and elevator servos are installed in the re